Advisory: This site contains documentation for the v1.12 release candidate version of Docker Engine. For the Docker Engine v1.11 docs, see https://docs.docker.com/v1.11/. Docker for Mac and Docker for Windows are currently in Beta.
The information in this section explains how to customize the Docker default bridge. This is a
bridge network named
bridge created automatically when you install Docker.
Note: The Docker networks feature allows you to create user-defined networks in addition to the default bridge network.
By default, the Docker server creates and configures the host system’s
docker0 interface as an Ethernet bridge inside the Linux kernel that can pass packets back and forth between other physical or virtual network interfaces so that they behave as a single Ethernet network.
docker0 with an IP address, netmask and IP allocation range. The host machine can both receive and send packets to containers connected to the bridge, and gives it an MTU -- the maximum transmission unit or largest packet length that the interface will allow -- of 1,500 bytes. These options are configurable at server startup:
--bip=CIDR -- supply a specific IP address and netmask for the
docker0 bridge, using standard CIDR notation like
--fixed-cidr=CIDR -- restrict the IP range from the
docker0 subnet, using the standard CIDR notation like
172.16.1.0/28. This range must be an IPv4 range for fixed IPs (ex: 10.20.0.0/16) and must be a subset of the bridge IP range (
docker0 or set using
--bridge). For example with
--fixed-cidr=192.168.1.0/25, IPs for your containers will be chosen from the first half of
--mtu=BYTES -- override the maximum packet length on
Once you have one or more containers up and running, you can confirm that Docker has properly connected them to the
docker0 bridge by running the
brctl command on the host machine and looking at the
interfaces column of the output. Here is a host with two different containers connected:
# Display bridge info $ sudo brctl show bridge name bridge id STP enabled interfaces docker0 8000.3a1d7362b4ee no veth65f9 vethdda6
brctl command is not installed on your Docker host, then on Ubuntu you should be able to run
sudo apt-get install bridge-utils to install it.
docker0 Ethernet bridge settings are used every time you create a new container. Docker selects a free IP address from the range available on the bridge each time you
docker run a new container, and configures the container’s
eth0 interface with that IP address and the bridge’s netmask. The Docker host’s own IP address on the bridge is used as the default gateway by which each container reaches the rest of the Internet.
# The network, as seen from a container $ docker run -i -t --rm base /bin/bash $$ ip addr show eth0 24: eth0: <BROADCAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000 link/ether 32:6f:e0:35:57:91 brd ff:ff:ff:ff:ff:ff inet 172.17.0.3/16 scope global eth0 valid_lft forever preferred_lft forever inet6 fe80::306f:e0ff:fe35:5791/64 scope link valid_lft forever preferred_lft forever $$ ip route default via 172.17.42.1 dev eth0 172.17.0.0/16 dev eth0 proto kernel scope link src 172.17.0.3 $$ exit
Remember that the Docker host will not be willing to forward container packets out on to the Internet unless its
ip_forward system setting is
1 -- see the section on Communicating to the outside world for details.